Products

Flux Density Controller

The Flux Density Controller has been designed to ensure and maintain consistent fluxing results by accurately controlling flux density.

Variable flux density is known to be a major cause of inconsistent soldering. Flux with too much thinners can be too dilute to be effective and can be burnt off before it has had a chance to work. Using not enough thinners is expensive and causes problems with fumes and component contamination.

Manually adding flux and thinners directly to a flux bath can be time consuming and messy as well as giving inconsistent results. The flux density may start off correct, but after a short while the thinners content has dropped and the density varies.

The FDC overcomes these problems to give total control of flux quality at all times.

Category:

Standard Features

 

  • Tank construction all stainless steel.
  • All external surfaces stove enamelled.
  • Totally enclosed fan cooled AC induction motors with thermal cut-outs to flux and solvent impeller pumps.
  • Controls on one circuit board inside sealed ABS enclosure.
  • External indication by illuminated indicator of:
    Flux pump running
    Solvent pump running
    Flux low level
    Solvent low level
  • Remote indication of:
    Machine running
    Flux low level
    Solvent low level
  • External drain taps for each compartment

 

Optional Extras

  • Flux Tank Upgrade (Applicable to Cadet Only)
  • Recommended Spares Kit
  • Additional Hydrometer
  • 1st Level Spares Kit

Specifications

  • Height: 415mm / 161/2”
  • Width: 280mm / 11“
  • Length: 550mm / 211/2”
  • Flux capacity: 9 litres
  • Solvent capacity: 9 litres
  • Accuracy: +/- 0.01 g/cm3
  • Density range: 0.790 – 0.860, 0.830 – 0.390, 0.890 – 0.930
    – Please specify when ordering
  • Power supplies: Single phase + PE
  • Voltage: 208V – 250V
  • Frequency: 50/60Hz

Please fill in your details below to be taken to our brochure downloads page.

Which country are you from?

Pillarhouse International Ltd will use the information you provide on this form to be in touch with you and to provide updates and marketing. Please let us know all the ways you would like to hear from us:

EmailDirect MailCustomised Online Advertising

captcha